Frontpanel
Here is the design for the frontpanel. I’ve choose a lo-fi option instead of Schaeffer engraving. It’s just a print on photo paper that is glued on a 2mm aluminium board. On top of the photo paper there’s a plastic film for protection.
I’ve got it done by a specialist that does this normally for photography exhibitions. It reduced the cost by much compared to Schaeffer. Drilling the panel was a pain in the a**…
Download the pdf :
Wiring diagram
Below is the wiring diagram I used to remember what goes where…
Download the pdf :
Case
For the case I needed something portable since it’s gonna travel a lot for gigs. I’ve build an inner case in MDF to hold the modules. It’s a bit heavier but more secure. It also holds the frontpanel (see pictures for details)
Wiring
